Work for the can lights is underway!
We started by breaking out the CNC again. We cut four 12×96″ wide strips of plywood and used the CNC to slice out six super-precise mounting holes in each:
Then, we cut sheets of 1″ rigid insulation for each by and a series of side spacers. The insulation will act as a “cap” to each light and allow us to safely spray foam the interior of the structure once the electrical is finished:
Finally, we installed each strip of plywood end-to-end, capped off every other spacer, and glued in the side bracing for the bays which will contain a light:
This is more of a preparation stage for the lights. Hopefully, we will have them wired in this week.